Configuring the IPv6 Settings
Click the [IPv6 Configuration] tab on the network settings page to configure the IPv6 settings.
IPv6
Item Description
IPv6 Select whether to enable or disable IPv6. You cannot disable IPv6 using
Web Image Monitor if the printer is currently in use in an IPv6 environment.
In this case, use the control panel to disable [IPv6] under [Network Setting].
When disabled, [DHCP], [Manual Configuration Address], [Prefix Length],
and [Gateway Address] below cannot be configured.
IPv6 Address
Item Description
DHCP Select whether or not the printer obtains its IPv6 address from a DHCP
server.
IP Address (DHCP) Displays the IPv6 address obtained from the DHCP server when [DHCP] is
set to [Active].
Stateless Address Displays up to four stateless auto addresses.
Gateway Address Displays the printer's default gateway address.
Link-local Address Displays the link local address of the printer. The link local address is an
address that is valid only inside the local network (local segment).
Manual Configuration
Address
Enter the printer's IPv6 address. Can contain up to 39 characters.
Prefix Length Enter the prefix length using a value between 0 and 128.
Gateway Address Enter the default gateway's IPv6 address. Can contain up to 39 characters.
5. Monitoring and Configuring the Printer
78
To Next Page
Loading...
