System Menu
You can set basic functions required to use the printer. The printer can be used on factory default, but the
configuration can be changed depending on the condition of the user. The changed condition holds
even if the printer is turned off.
Changing the System Menu
Use the following procedure to change the settings for Energy Saver 2 timer.
1. Press the [Menu] key.
The menu screen appears.
2. Press the [ ][ ] keys to select [System], and then press the [OK] key.
3. Press the [ ][ ] keys to select [Energy Saver 2], and then press the [OK] key twice.
4. Press the [ ][ ] keys to select [On], and then press the [OK] key.
5. Press the [ ][ ] keys to select [E.Saver2 Timer], and then press the [OK] key.
6. Specify the lead time needed to switch to the Energy Saver mode using [ ][ ] keys.
7. Press the [OK] key.
The selected lead time is displayed for two seconds with an asterisk, and then the [Energy Saver 2]
screen appears.
8. Press the [Menu] key to return to the initial screen.
System Menu Parameters
This section explains about parameters that can be set on the System menu.
System Menu
49
To Next Page
Loading...
