• On
•
Off
Blank Pg. Print
Sets the printer to print blank pages.
When cover sheet printing is enabled from the printer driver, cover sheets are inserted even if you
select [Off].
Note that this setting has lower priority than the printer driver's blank page setting ([Do not Print
Blank Pages] on the [Setup] tab of the PCL6 printer driver, or [Print Blank Pages] under [Printer
Features] of the PostScript 3 printer driver).
Default: [On]
• On
• Off
Energy Saver 1
Sets the printer to enter Energy Saver mode 1 if the printer has been idle for about 30 seconds. It
takes less time to recover from Energy Saver mode 1 than from power-off state or Energy Saver
mode 2, but power consumption is higher in Energy Saver mode 1 than in Energy Saver mode 2.
Default: [Off]
• Off
• On (30 seconds)
Energy Saver 2
Sets the printer to enter Energy Saver mode 2 after the period of time specified for this setting is
passed. The printer consumes less power in Energy Saver mode 2 than in Energy Saver mode 1,
but it takes longer to recover from Energy Saver mode 2 than from Energy Saver mode 1.
Default: [On] (1 minute)
• On (1 to 240 minutes, in 1 minute increments)
• Off
Restore Default
Resets the printer settings to their factory-set defaults. Rebooting the printer is required after you are
requested to do so on the control panel.
Image Density
Adjusts the printer's image density.
Default: "0"
• -3 to 3
System Menu
51
To Next Page
Loading...
