6. Insert the new friction pad in the paper tray.
Attach the central projection of the new friction pad to the spring, and then align the projections on
both sides of the friction pad with the holes in the paper tray. Then push the friction pad as shown in
the illustration until it clicks.
After pushing in the friction pad, press on it several times to check it is properly installed. If it jumps
back into position due to the force of the spring, it is properly installed.
7. Push the friction pad until it locks securely.
8. Repeat the replacement procedure for any optional paper feed units that are installed.
• The friction pad spring may come off. Be careful not to lose the friction pad spring.
• The catches that lock the friction pad are located at the very back.
Replacing the Transfer Roller
• Do not insert the roller on the back of the socket. Doing so can damage the printer.
7. Maintaining the Printer
164
To Next Page
Loading...
