Ricoh Aficio SP 4310N - Page 61

CEE059
12. Push the handle of the controller board until it clicks.
CEE106
13. Fasten the controller board to the printer with the two screws.
CEE138
First install the optional hard disk, and then install the SD card provided with the hard disk. For details
about the installation procedure, see p.71 "Installing the SD Memory Card Options".
• After finishing installation, you can check whether the hard disk is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Hard Disk"
will appear for "Device Connection" on the configuration page.
• If the Hard disk is not properly installed, repeat this procedure. If you cannot install it properly even
after reinstallation, contact your sales or service representative.
Installing the Memory Expansion Units
59
3