SH-P1 Training
84
Slide 84
Energy Saver Mode
When the machine is not being used, the energy saver
feature reduces power consumption by switching off the
fusing lamp.
Entering Energy Saver Mode
Energy saver mode starts after the machine has been idle
for a specified time. The operator can set the time on the
System menu. ([Menu] > "System"]. Several settings are
available: Off, 1, 5, 15, 30, 45, 60 min (Default: 5 min.)
When the machine is in energy saver mode, the CPU turns
off the fusing lamp. The +5VE (power enabled in energy
saver mode) line is active in energy saver mode; however,
the +24V and +5V lines are not active.
Leaving Energy Saver Mode
The machine leaves energy saver mode when one of the
following events occur:
» Print command received from the PC
» Any cover opened and closed
» Any operation panel keys pressed
No additional notes.
To Next Page
Loading...
