Ricoh FF-1 - Automatic Exposure Settings; Shutter Speed Checking

* Please note. however. intermediate position
in-between the two ASA settings will not give you
the correct exposures. i.e
.. if you use ASA 64.
please set at click position
of ASA 50 .
AUTOMATIC EE EXPOSURE
Set the camera to "AUTO"
1. Rotate Auto/Manual Ring (11) until the " A" is set
opposite the index line (Fig. 15).
Your camera sets the aperture and the shutter
speed automatically.
Shutter Speed Checking
1. Advance Film Advance Lever (12).
2. Press Shutter Release Button (7) lightly half way
down and check to see the slow shutter speeds
warning
LED (Red) above the viewfinder (Fig. 16).
If the LED (Red) turns on and stays on. hold the
camera
as steadily as possible to prevent camera
movement and blurred pictured and also keep
pressing Shutter Release Button (7) until LED turns
off because the shutter speed is slower than 1/ 60
sec. We suggest you use a tripod or flash.
3. When the
LED does not turn on. press Shutter
Release Button (7)
as it is since the shutter speed is
faster than 1/60 sec .
- 6-
\
\