"A function which
cannot be used with
Fold mode was set.
The job has been
cancelled."
A setting that
cannot be specified
with folding was
specified, and
printing was
canceled.
Check the setting, and cancel the function
that cannot be specified with the fold
function.
"A job via the
network that was
not printed exists
because an error
occurred. It was
stored as a job not
printed."
When the error job
storing function is
enabled, an error
occurred in the
print job sent via
the network and the
canceled job was
stored.
• Check that the machine is connected
to the network correctly. For details
about your network environment,
consult the administrator.
• The stored document can be printed.
page168”Printing Documents Stored
in the Printer from the Control Panel”
"All the remaining
print volume has
been allocated to
another central
managed client(s).
The job has been
cancelled."
The job was
canceled because
the usage count
information could
not be obtained
from the Central
Management
machine.
All job slots are occupied by other
devices. Check the status of the client
machine.
"An error occurred
while printing a job
with Background
Numbering. The job
has been
cancelled."
A size that is
impossible to print
was specified.
Specify a size smaller than 305.0 mm
(12.0 inches) wide and 432.0 mm (17.0
inches) long in "Print On:" in the printer
driver. When [Same as Original Size] is
specified in "Print On:", reduce the size
specified in "Print On:" or adjust the size
in the application.
"An error occurred
while processing an
Unauthorized Copy
Prevention job. The
job was cancelled."
The settings in the
printer driver are
incorrect.
Check the following in the printer driver:
• Is a value smaller than 600 dpi
specified in [Resolution]?
See "Applying Different Print Settings
Depending on the Document Type",
User Guide (HTML).
• Is only space(s) entered as the text to
use for the background pattern in the
unauthorized copy prevention
function?
To Next Page
Loading...
