0
Key Acquisition
Key can be acquired.
• Replace the controller board.
1
HDD Key Setting Error
The key is acquired but the HDD can not be set.
• Turn the machine power off/on several times.
•
Replace the controller board.
2
NVRAM Read Error
NVRAM data conversion fails (mismatch with nvram.conf).
• Replace the NVRAM.
30
NVRAM Before Replace Error
An error which may be recovered after recycling the power occurs before replacing
NVRAM.
Turn the machine power off/on several times.
Replace the controller board.
31 Other Error
An unexpected error occurs while data is being converted. This error is the same as
SC991. See SC991 below.
859
B
Data Encryption Error 2
These are errors of the HDD Data Encryption Option.
8
HDD Check Error
Data conversion is attempted with no HDD unit present.
• Confirm that HDD unit installed correctly.
•
Initialize HDD with SP5832-1.
Note: After installation, a new HDD should be formatted with SP5832-1.
SC Conditions
207
To Next Page
Loading...
