9
Power Loss During Data Conversion
Data conversion stops before NVRAM/HDD data is converted.
• Format HDD with SP5832-1.
10
Data Read Command Error
More than two illegal DMAC communications are returned.
• HDD defective
•
Format HDD with SP5832-1.
• Replace HDD.
860
B
HDD startup error at power on
HDD is connected but a driver error is detected.
-or-
The driver does not respond with the status of the HDD within 30 s.
• HDD is not initialized.
•
Level data corrupted
• HDD is defective.
861
D
HDD re-try failure
At power on the HDD is detected. Power supply to the HDD is interrupted after the system
has entered the energy save mode, but after the HDD has been awakened from the
energy save mode it does not return to the ready status within 30 sec.
• Harness between HDD and controller board disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
863
D
HDD data read failure
6. Troubleshooting
208
To Next Page
Loading...
