• Security card is not inserted completely into the SD card slot
•
Security card has been removed from the SD card slot.
• Security card is damaged.
Note:
• If the SD card has been removed (or was not installed correctly), switch the machine
off, insert the SD card, then switch on the machine again.
• If the SD card has been damaged, procure a new SD card, replace the NVRAM,
then do the DOS and HDD encryption installation.
878
D
TPM authentication error CTL
The system firmware could not be authenticated by the TMP security chip.
• System firmware updated incorrectly.
•
Flash ROM on controller board defective.
• Replace controller board.
881
D
Authentication Log Management Error
When logged errors of an application reach the maximum number of the authentication
log management, this SC is issued.
• Authentication error of an application
Turn off and on the machine.
899
D
GW Controller Error
When one of processes in the GW controller gets an error in its processing, the machine
stops and issues this SC.
• Firmware old or defective
• GW controller defective
1. Updates the latest firmware of the GW controller.
2. Replace the GW controller board.
SC Conditions
213
To Next Page
Loading...
