Ricoh MD-P2 - Engine SP1-xxx (Feed)

Engine SP1-xxx
SP1-XXX (Feed)
1001
[Lead Edge Reg.] Leading Edge Registration
(Tray or By-pass, Paper Type, Process Speed)
Process Speed: LowSpd: Low Speed, HlfSpd: Half speed, NorSpd: Normal speed
• Adjusts the leading edge registration. This SP changes the registration clutch
operation timing for each mode.
•
A +ve value sets the registration start timing earlier.
• A –ve value sets the registration start timing later. The value of the normal paper in
RS is the standard value. The values of papers other than normal are added to the
value of the normal paper in RS.
002 T1:NorSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
003 T1:HlfSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
006 T2:NorSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
007 T2:HlfSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
014 ByPas:NorSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
015 ByPas:HlfSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
018 Dup:NorSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
021 Dup:HlfSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
063 T1:LowSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
065 ByPas:LowSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
066 Dup:LowSpd 0.3mm *EGB [-9.0 to 9.0 / 0 / 0.3 mm/step]
100 Mar.pos 0:OFF1:ON *EGB [0 or 1 / 0 / -/step]
1002 [S-to-S Reg.] Side-to-Side Registration
Engine SP1-xxx
23
3