Ricoh MD-P2 - Page 256

001 By-pass 0.0846mm *EGB
Adjusts the side-to-side registration for each
mode.
This SP changes the laser main scan start
position.
[-63 to 63 / 0 / 0.0846 mm /step]
002 Tray1 0.0846mm *EGB
003 Tray2 0.0846mm *EGB
004 Duplex 0.0846mm *EGB
1003
[Paper Buckle] Paper Buckle
(Tray or By-pass, Paper Type, Process Speed)
002 Tray1 0.1mm *EGB
Adjusts the amount of paper buckle at the
registration roller for each mode. This SP
changes the paper feed timing.
[-10.0 to 10.0 / 0.0 / 0.1 mm/step]
006 Tray2 0.1mm *EGB
014 By-pass 0.3mm *EGB
018 Duplex 0.1mm *EGB
1100
[Lead Edge Reg.] Leading Edge Registration
(Tray or By-pass, Paper Type, Process Speed)
Process Speed: LowSpd: Low Speed, HlfSpd: Half speed, NorSpd: Normal speed
These SPs can be adjusted by UP mode. The setting range of SP1100 is different from the
setting range of SP1001.
002 T1:NorSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
003 T1:HlfSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
006 T2:NorSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
007 T2:HlfSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
014 ByPas:NorSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
015 ByPas:HlfSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
018 Dup:NorSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
021 Dup:HlfSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
063 T1:LowSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
065 ByPas:LowSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
066 Dup:LowSpd 0.3mm *EGB [0 to 9.0 / 0 / 0.3 mm/step]
3. Appendix: SP Mode Tables
24
3