Ricoh MD-P2 - Page 257

1102 [S-to-S Reg.] Side-to-Side Registration
These SPs can be adjusted by UP mode. The setting range of SP1102 is different from the
setting range of SP1002.
001 By-pass 0.34mm *EGB
Adjusts the side-to-side registration for each
mode.
This SP changes the laser main scan start
position.
[-15 to 15 / 0 / 0.34 mm /step]
002 Tray1 0.34mm *EGB
003 Tray2 0.34mm *EGB
004 Duplex 0.34mm *EGB
1105
[Temp. Adj.] Temperature Adjustment
Adjusts the fusing unit subtractive value for the target temperature of each paper type.
001
Fusing Temp. *EGB [1 to 16 / 16 / 1 /step]
16: No adjustment
15: -2°C
14: -4°C
13: -6°C
12: -8°C
11: -10°C
10: -12°C
9: -14°C
8: -16°C
7: -18°C
6: -20°C
5: -22°C
4: -24°C
3: -26°C
2: -28°C
1: -30°C
1159 [Fusing JAM SC] Fusing JAM SC Setting
001 Detect 0:OFF 1:ON *EGB
Turns on or off the fusing jam SC to detect the three
consecutive paper jams at fusing unit.
[0 or 1 / 0 / 1 /step]
0: OFF, 1: ON
1900
[Print Support]
These SPs can be adjusted by UP mode.
Engine SP1-xxx
25
3