5816 013 RFU Timing *CTL
Selects the timing for the remote firmware
updating.
[0 or 1 / 1 / – ]
0: Any status of a target machine
1: Sleep or panel off mode only
5816 021 Function Flag *CTL
[0 or 1 / 0 / -]
0: Not registered, 1: Registered
5816 022 Install Status *CTL
This SP displays the RCG-N installation status.
0: RCG-N not registered
1: RCG-N registered
2: Device registered
5816 023
Connect Mode (N/M) *CTL
This SP displays and selects the RCG-N connection method.
0: Internet connection
1: Dial-up connection
5816 061
NotiTime ExpTime *CTL
Proximity of the expiration of the certification.
5816 062
HTTP Proxy use *CTL
This SP setting determines if the proxy server is used when the machine communicates
with the service center.
5816 063
HTTP Proxy Host *CTL
This SP sets the address of the proxy server used for communication between Cumin-N
and
the gateway. Use this SP to set up or display the customer proxy server address. The
address is necessary to set up Cumin-N.
• The address display is limited to 127 characters. Characters beyond the 127th
character are ignored.
• This address is customer information and is not printed in the SMC report.
Engine SP5-xxx
49
To Next Page
Loading...
