When the machine starts up, this function is used to check that the firmware is valid.
If an error occurs while a verification process is performed, a verification error is displayed on
the control panel.
Note that this can also be checked on Web Image Monitor after the machine starts. If an error
occurs in a verification process of Web Image Monitor, Web Image Monitor cannot be used. If
this is the case, check the control panel.
When an error occurs in a verification process, contact your service representative.
If this machine is connected to a network, its environment must be protected by a firewall or
similar security measure.
For protection of data during communication, apply the machine's communication security
functions and connect it to devices that support security functions such as encrypted
communication.
Administrators should regularly examine the machine's logs to check for irregular and unusual
events.
Checking Firmware Validity
Section Top
Introduction | Registering Standard-Privileges Administrators
Page Top
To Next Page
Loading...
