Only the administrator can change the user code. To change the user code, log in to Web
Image Monitor as an administrator.
1. Launch the Web browser.
2. Enter "http://(IP address of the machine or host name)/" on the address bar of the
Web browser, and then press the Enter key.
3. Click [Login].
4. Enter the login user name and password, and then click [Login].
5. Click [Address Book] on the [Device Management] menu.
6. Select the user for whom to change the login password.
7. Click [Change].
8. Click [Change] in "Login Password" of "Authentication Information".
9. Enter the new password in [New Password], and then re-enter the password in
[Confirm Password].
10. Click [OK] three times.
Section Top
Changing the Login Password by Using Web Image Monitor
Section Top
To Next Page
Loading...
