Ricoh MP C4503 Series User Manual

Loading Paper into Paper Trays
Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded into Tray 2.
• (mainly Europe and Asia)
Tray 1 can hold A4 paper only. If you want to print on A5 , B5 JIS , or 8
1
/
2
× 11 from Tray
1, contact your service representative.
• (mainly North America)
Tray 1 can hold 8
1
/
2
× 11 paper only. If you want to print on A4 , A5 , or B5 JIS from Tray
1, contact your service representative.
• Check the paper edges are aligned at the right side.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, thin paper may
wrinkle, or the paper may misfeed.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
CVA010
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
9. Adding Paper and Toner
130

Ricoh MP C4503 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Standard Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Monthly Duty Cycle	200, 000 pages
Print Technology	Laser
Fax Speed	33.6 Kbps
Print Speed	45 ppm
Paper Capacity	4, 700 sheets
Connectivity	USB, Ethernet, Wi-Fi
Scan Resolution	600 dpi
Memory	2 GB
Control Panel	9-inch color touchscreen
Operating System Compatibility	Windows, Mac, Linux