5. Push the ADF sheet until it clicks.
Adjusting Color by Auto Color Calibration
If the message "The printing speed is now being limited because the internal cooling fan is active"
appears, [Auto Color Calibration] cannot be executed. Wait until the message disappears, and then
execute the function.
1. Press [Settings] on the Home screen.
2. Press [Maintenance] [Auto Color Calibration].
3. Press [Start Auto Calibration] of the function to perform adjustment, and print the test
pattern.
4. Open the ADF.
5. Place the printed test pattern on the exposure glass.
Align the arrow on the test pattern with the rear left corner on the exposure glass.
Place two or three blank sheets of white paper of the same size on the test pattern.
6. Close the ADF.
7. Press [Start Scanning].
8. Press [Home] ( ) after performing the adjustment.
7. Troubleshooting
110
To Next Page
Loading...
