• Arrange with the side to scan face down.
• Be careful not to get your hand caught in the ADF.
4. Make desired settings.
Specify settings such as the size of the original, color / black & white, magnification and number of
copies.
5. Press [Start].
When placing the original on the exposure glass, press [Start] and then press [ ] after the original
has been scanned.
Copying in Color
Automatically selecting a color mode
In the Auto Color Select mode, the color of the original is detected automatically, and the original will
be copied either in full color or black and white.
1. Press [Auto Color Select].
Registering a specific color
Creates colors by adjusting the density of primary colors based on a chosen basic color.
1. Press [Edit / Color].
2. Press [Color].
3. Press [User Color].
4. Select the number for the color you want to register.
5. Select the color to be used as base color.
To select user color, press [User Color], and then select the color.
6. Select the color whose density is to be specified, and then specify the density in
percentages using [ ] or [ ].
5. Using Advanced Functions
58
To Next Page
Loading...
