3. Carefully push the paper tray fully in.
• If you select Paper Weight 5 to 8, [Coated: Glossy], [Coated: Matte], [Coated Paper: Gloss], or
[Label Paper] in [Tray Paper Settings], air is blown out automatically to fan the paper loaded in the
three-tray wide LCT. Fan this paper before loading it. For details, see page 121 "Fanning the
paper".
• Various sizes of paper can be loaded in the three-tray wide LCT by adjusting the positions of side
fences and end fence. For details, see page 141 "Changing the Paper Size in the Three-tray Wide
Large Capacity Tray".
• You can load envelopes in the three-tray wide LCT. When loading envelopes, place them in the
correct orientation. For details, see page 177 "Envelopes".
Loading Paper into the Two-tray Wide Large Capacity Tray
The two-tray wide LCT is identified as Tray 3, Tray 4, Tray 5, Tray 6, Tray 7, and Tray 8.
• Check the paper edges are aligned at the left side.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
4. Paper Specifications and Adding Paper
130
To Next Page
Loading...
