Other Security Functions
This section explains the settings for preventing information leakage.
System Status
Pressing the [Check Status] key on the control panel allows you to check the machine's current status and
settings. If administrator authentication has been specified, [Machine Address Info] is displayed in
[Maintnc./Inquiry/Mach. Info] only if you have logged in to the machine as an administrator.
Checking Firmware Validity
When the machine starts up, this function is used to check that the firmware is valid.
If an error occurs while a verification process is performed, a verification error is displayed on the
control panel.
Note that this can also be checked on Web Image Monitor after the machine starts. If an error occurs in
a verification process of Web Image Monitor, Web Image Monitor cannot be used. If this is the case,
check the control panel.
6. Managing the Machine
168
To Next Page
Loading...
