Tab Item Setting
Administrator
Tools
Extended Security
Password Policy
"Complexity Setting": Level 1 or higher,
"Minimum Character No.": 8 or higher
See page 162 "Specifying the Extended
Security Functions".
Administrator
Tools
Network Security Level Level 2
To acquire the machine status through printer
driver or Web Image Monitor, enable "SNMP"
on Web Image Monitor.
See page 77 "Specifying Network Security
Levels".
Administrator
Tools
Service Mode Lock On
See page 169 "Restricting a Customer
Engineer Operation".
Administrator
Tools
Machine Data Encryption
Settings
Select [Encrypt], and then select [All Data] for
"Carry over all data or file system data only
(without formatting), or format all data.".
If [Encrypt] has already been selected, further
encryption settings are not necessary.
See page 55 "Encrypting Data on the
Machine".
• The SNMP setting can be specified in [SNMP] under [Configuration] in Web Image Monitor.
Settings You Can Configure Using Web Image Monitor
Use Web Image Monitor to configure the security settings shown in the following table.
Device Management
Configuration
Category Item Setting
Device Settings
Logs
Collect Job Logs Active
Device Settings
Logs
Collect Access Logs Active
Additional Information for Enhanced Security
171
To Next Page
Loading...
