Restricting a Customer Engineer Operation
You can restrict the customer engineer's access to the service mode.
A customer engineer uses service mode for inspection or repair. If you set "Service Mode Lock" to [On],
service mode cannot be used unless the machine administrator logs on to the machine and cancels the
service mode lock to allow a customer engineer to operate the machine for inspection and repair. This
ensures that inspection and repair can be performed under the supervision of the machine administrator.
1. Log in as the machine administrator from the control panel.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [ Next] twice.
5. Press [Service Mode Lock].
6. Press [On], and then press [OK].
7. Press [Yes].
8. Log out.
Restricting a Customer Engineer Operation
169
To Next Page
Loading...
