Ricoh PRO C9110 - 7. Troubleshooting; If a Message is Displayed

Control panel settings
System Settings
Tab Item Setting
Interface Settings IPsec Active
Interface Settings Permit SSL / TLS
Communication
Ciphertext Only
Web Image Monitor settings
Device Management Configuration
Category Item Setting
Security IPsec
Encryption Key
Auto Exchange
Settings
Edit Security Level Authentication and High Level Encryption
Settings you can configure when IPsec is unavailable
If IPsec is not available, configure the settings shown in the following table to enhance the security of the
data traveling on your network.
Control panel settings
System Settings
Tab Item Setting
Interface Settings IPsec Inactive
Interface Settings Permit SSL / TLS
Communication
Ciphertext Only
• You can set "IPsec" and "Permit SSL/TLS Communication" using Web Image Monitor.
Additional Information for Enhanced Security
173