Ricoh PRO C9110 - Protecting Communication Paths via a Device Certificate

Function Level 0 Level 1 FIPS 140 Level 2
SSL/TLS > Permit SSL/TLS
Communication
Ciphertext
Priority
Ciphertext
Priority
Ciphertext
Only
Ciphertext
Only
SSL/TLS Version > TLS1.2 Active Active Active Active
SSL/TLS Version > TLS1.1 Active Active Active Active
SSL/TLS Version > TLS1.0 Active Active Active Active
SSL/TLS Version > SSL3.0 Active Active Inactive Inactive
Encryption Strength Setting > AES
128bit/
256bit
128bit/
256bit
128bit/
256bit
128bit/
256bit
Encryption Strength Setting > 3DES 168bit 168bit 168bit -
Encryption Strength Setting > RC4 - - - -
FTP Active Active Active Active
sftp Active Active Active Active
ssh Active Active Active Active
RSH/RCP Active Active Inactive Inactive
TELNET Active Inactive Inactive Inactive
Bonjour Active Active Inactive Inactive
SSDP Active Active Inactive Inactive
SMB Active Active Inactive Inactive
NetBIOS over TCP/IPv4 Active Active Inactive Inactive
The same settings are applied to IPv4 and IPv6.
TCP/IP setting is not controlled by the security level. Manually specify whether to enable or disable
this setting.
SNMP
Function Level 0 Level 1 FIPS 140 Level 2
SNMP Active Active Active Active
Permit Settings by SNMPv1 and v2 On Off Off Off
Specifying Network Security Levels
79