Ricoh Russian-C2a - Page 201

SERVICE PROGRAM MODE 10 August, 2001
4-38
5
Mode Number/Name Function/[Setting]
28* Network Time Server
Address Setting
Sets the time server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
29*
Network DNS Server
Address Setting
Sets the DNS server address for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
30* Network Directprint Port
Number Setting
Sets the directprint port number for the network.
[1024~65535 / 9100 / 1 step]
31*
Network IPP Timeout
Setting
Sets the IPP timeout for the network.
[30~65535 / 900 / 1 step]
32 Network IPX Address
Setting (NetWare)
Sets the IPX Address.
33* Network Remote
Printer Number Setting
(NetWare)
Sets the remote printer number for the network.
[0~254 / 0 / 1 step]
34*
Network Software
Switch Setting
(NetWare)
Sets the software switch for the network.
[0000~FFFFh / 0003h / 1 hex unit step]
35*
Network Transport
Protocol of Print Server
Setting (NetWare)
Sets the transport protocol of the print server for the
network.
0000h: TCP & IPX
0100h: TCP& IPX (Priority: IPX)
0102h: TCP Only (Priority: TCP)
0001h: IPX Only
36 Network AppleTalk
Module Setting
Sets the AppleTalk module for the network. DFU
2: EtherTalk Phase2
37 Network NetNo Setting
(AppleTalk)
Sets the NetNo of the AppleTalk network.
38 Network Object Name
Setting (AppleTalk)
Sets the object name of the AppleTalk network.
39* Network AppleTalk
Type Setting
Sets the AppleTalk type for the network.
40
Network Working Zone
Setting (AppleTalk)
Sets the AppleTalk working zone for the network.
47* Network Job Analysis
Timeout Setting
(Centronics)
Sets the Centronics job analysis timeout for the
network.
[0~43200 s / 3 s / 1 sec. step]
48* Network Job Timeout
Setting (Centronics)
Sets the Centronics job timeout for the network.
[0~43200 s / 0 s / 1 sec. step]
49* Network Noise Cancel
Setting (Centronics)
Sets the noise cancel level for the network.
[4~7 / 4 / 1 clock per step]
50* Network 1284
Compatibility Setting
(Centronics)
Switches Centronics IEEE1284 compatibility on/off for
the network.
0: Disabled, 1: Enabled
Selecting “0” disables bi-directional data transmission.
51* Network Data Transfer
Speed Setting
(Centronics)
Sets the Centronics transfer speed for the network.
0: SLOW, 1: FAST
If you select “0” there will be a 120
µ
s delay from the
STP signal to the data transfer. (With 1: FAST there is
no delay.)
828*
52*
Network ECP Setting
(Centronics)
Switches the ECP setting for Centronics off/on.
0: Disabled, 1: Enabled
With “1” selected, SP5-828-050 must be enabled for
1284 mode compatibility.