• For details about configuring infrastructure mode, see Wi-Fi Settings Guide.
Configuring the Ad hoc mode using Smart Organizing Monitor
• In Ad Hoc network, every device must be manually assigned an IP address for TCP/IP if there is no
DHCP server.
• If [Communication Mode:] is set to [802.11 Ad-hoc Mode], [WPA2 - PSK -AES] and [WPA/
WPA2 Mixed Mode] in [Security Method:] cannot be selected.
1. Connect the machine and the computer with a USB cable.
2. On the [Start] menu, click [All Programs].
3. Click [Smart Organizing Monitor for SP xxx Series].
4. Click [Smart Organizing Monitor for SP xxx Series Status].
5. If the machine you are using is not selected, click [Select Device...], and then select the
machine's model.
6. Click [OK].
7. On the [User Tool] tab, click [Printer Configuration].
8. On the [Wi-Fi] tab, set [Communication Mode:] to [802.11 Ad-hoc Mode].
9. In [SSID:], enter the SSID.
The characters that can be used are ASCII 0x20-0x7e (32 characters).
10. Select [Security Method:].
11. In the [Channel Number:] box, enter the channel number.
12. Specify the appropriate settings in [WEP / WPA / WPA2 Settings].
The maximum number of characters that can be entered in [WEP Key / Passphrase (PSK):]
depends on the [Key Length:] and [Key Format:] settings. Specify settings in accordance with the
following table:
Security Method Key Length Key Format
WEP Key
(Maximum character)
Open System - None
*1
- - -
Configuring Network Settings
17
To Next Page
Loading...
