Security Method Key Length Key Format
WEP Key
(Maximum character)
Open System – WEP 64 bit ASCII 5 characters
Hexadecimal 10 characters
128 bit ASCII 13 characters
Hexadecimal 26 characters
Shared Key – WEP 64 bit ASCII 5 characters
Hexadecimal 10 characters
128 bit ASCII 13 characters
Hexadecimal 26 characters
*1 The key length, key format, and WEP key cannot be configured.
13. Enter [WEP Key / Passphrase (PSK):].
14. If it is necessary to configure the IPv4 address, click [IPv4 Configuration].
The IPv6 address can be configured only by using Web Image Monitor.
15. Click [OK].
After a setting is changed, the machine automatically restarts.
16. Using the Wi-Fi status report, you can check whether the connection has succeeded or
failed.
If [Wireless LAN Status Report:] is set to [On], a report confirming the completion of wireless LAN
setup is printed. If "OK" appears for "Connection", the connection has succeeded. If "Failed"
appears for "Connection", try configuring the settings again.
Connecting in Ad-hoc mode using control panel
1. Make sure the Ethernet cable is not connected to the machine.
2. Switch on the machine.
Go to the next step after the power indicator has flashed three times.
3. Hold down the [Job Reset] key.
Hold the key down for two seconds or longer makes the power indicator flash.
1. Guide to the Machine
18
To Next Page
Loading...
