4. To select Ad-Hoc mode, press the [Job Reset] key.
If the machine has been set to Infrastructure mode, it reboots itself after Step 4 and switches to Ad-
hoc mode.
If [Wireless LAN Status Report:] is set to [On], a report confirming the completion of wireless LAN
setup is printed.
If "OK" appears for "Connection", the connection has succeeded. If "Failed" appears for
"Connection", try configuring the settings again.
• When configuring [Open System - WEP], the connection appears to have been established even if
you enter the wrong WEP key and the connection fails. In this case, enter the correct WEP key.
Configuring Network Settings
19
To Next Page
Loading...
