• 7.2 Kbps
• 4.8 Kbps
• 2.4 Kbps
Report Print Settings
• Print TX Status Report
Sets the machine to print a transmission report automatically after a fax transmission.
When the machine is in Immediate Transmission mode, the image of the original will not be
reproduced on the report, even if [Error Only (Image Attached)] or [Every TX (Image
Attached)] is selected.
Note that if a memory error occurs for PC-Fax transmission, a transmission report will always
be printed regardless of this setting.
The transmission report will be printed on A4 or Letter size paper.
Default: [Error Only (Image Attached)]
• Error Only
Prints a report when a transmission error occurs.
• Error Only (Image Attached)
Prints a report with an image of the original when transmission error occurs.
• Every TX
Prints a report for every fax transmission.
• Every TX (Image Attached)
Prints a report with an image of the original for every fax transmission.
• Do not Print
• Print Fax Journal
Sets the machine to print a fax journal automatically for every 50 fax jobs (both sent and
received).
Default: [Auto Print]
• Auto Print
• Do not Auto Print
Operation
You can simplify the procedure for sending and receiving faxes by disabling the use of the
exposure glass. If originals are loaded in the ADF, you can fax them using the ADF in either mode
by pressing the [Start] key.
Default: [Advanced Mode]
• Easy Mode
7. Configuring the Machine Using the Control Panel
142 opal-p2_mf2_com_user_guide_00142123_eng.xml
To Next Page
Loading...
Need help?
General
