Auto Continue
Item Description Value
Auto Continue Sets the machine to ignore an error
with paper size or type and continue
printing. The printing stops temporarily
when an error is detected, and restarts
automatically after about ten seconds
using the settings made on the control
panel.
• Off
• On
Default: [Off]
Toner Saving
Item Description Value
Toner Saving Sets the machine to print using a
reduced amount of toner (for prints
made by the copier function only).
• Off
• On
Default: [Off]
Toner End Option Settings
This function is available for only SP 221SF, SP 220SFNw, and SP 221SFNw.
Item Description Value
Toner End
Option
Settings
This setting is used to monitor the toner
level.
• Continue Printing
The machine no longer monitors
the toner level. Even when the
toner runs out, printing will
continue and no messages will
be displayed.
• Stop Printing
Monitoring the toner level is
enabled. The remaining toner
level can be checked in the
control panel and on Web
Image Monitor.
Default: [Stop Printing]
7. Configuring the Machine Using the Control Panel
182
To Next Page
Loading...
