Ricoh SP 230SFNw - Page 195

4-3
Confidential
(10) Click the [Serial No.] in the box
(F). The Serial No. screen
appears.
(11) Enter the serial number (11
digits) of the machine in the
box (J) and click the [Set]
shown as (K). “Set[***********]”
and entered value appears on
the “Serial No.” line in the box
(F). (“***********” indicates the
Serial No. entered.)
(12) Check the laser serial number label attached to the location shown in the illustration
below.
Ex.)
LUSA0123456011155555
Fig. 4-1
(13) Click the [Adjusted
Value(Laser)] in the box (F).
The Laser Adjusted Value
screen appears.
(14) Enter the last five digits of the
laser serial number in the box
(L), and click the [Set] shown
as (M). “Set[*****]” and entered
value appears on the “Adjusted
Value(Laser)” line in the box
(F). (“*****” indicates the laser adjusted value entered.)
(15) Click the [OK] shown as (N).
The Execute Setting screen shown on the right appears and
the setting by spec, setting serial number and entering
adjusted value of laser unit is written to the machine.
(16) Click the [OK] shown as (Q) and close the Execute Setting
screen.
(17) Click the [Cancel] shown as (P) and close the Input
Information screen.
(18) Click the [Get information] shown as (D).
The machine maintenance information appears.
(19) In the maintenance information, check that the spec code in the “Spec” field, Serial No.
in the “Serial No.” field and Laser Adjusted value in the “Laser Adjusted value(Position)”
field.
(F)
(J)
(K)
Laser unit
Laser serial number label
Scanner plate
(F)
(N) (P)
(L)
(M)
(Q)