4-4
Confidential
(20) Click the [Cancel] shown as (R) and
close the Get Information screen.
(21) Turn OFF the power switch of the
machine and disconnect the USB cable
from the machine and computer.
Note:
• The serial number can be set by referring to “1.3.23 Delete fax data (Function code
79)” in Chapter 5.
• For country code, refer to “1.3.20 Configure for country/region and model (Function
code 74)” in Chapter 5. Please contact Ricoh distributors for the latest information.
• When the supply PCB is replaced with a new one, the machine automatically enters
maintenance mode by turning it ON.
• Always turn the machine OFF and then ON again after setting the country. Turning the
power switch OFF and then ON again starts the EEPROM formatting. Time required
for formatting is 5 to 30 seconds depending on the product.
To Next Page
Loading...
