2-27
Confidential
SCANNER
ERROR FB
-
Detected that the CIS flat cable
was not inserted correctly when
function code 55 was executed.
B000 2-52
SCANNER
ERROR ADF
Self-
Diagnostic
Turn the power off,
then on again.
Leave the machine
for 15 min.
Some fuser unit errors occurred
at power-ON or upon recovery
from sleep mode.
6901 2-41
Will Automatically
Restart within 15
minutes.
After the error was detected at
the fuser unit, power was turned
ON again and the error is being
checked. (If power is turned
OFF and ON after error code
6901 occurred, this code is
displayed for about 15 minutes.)
6902 2-41
Size Error Specify the correct
paper size for Tray
1.
For printing by feeding paper
from the paper tray, the size of
paper specified from the driver
set the size which was not
supported by the paper tray.
9702 2-48
Size Error DX Press Stop Key.
Specify the correct
paper and load the
same size paper as
the Printer driver
setting.
For 2-sided printing, paper size
setting of the printer driver that
was not supported by 2-sided
printing was selected.
9701 2-48
Specify the correct
paper.
The registration rear sensor
detected that the paper fed was
smaller or larger than the
specified size in duplex printing
mode.
8A01 2-45
Size mismatch Fax received. Set
correct paper size
in menu.
Paper size is not set as A4/
Letter/Legal/Folio when
receiving fax or printing a list/
report.
8E01 2-45
Reload correct
paper in Tray1, then
press Start.
The size of paper loaded in the
paper tray and the one specified
from the driver are not same
when paper is fed from the
paper tray.
9002 2-46
Reload correct
paper, then press
Start.
Detected that the size of paper
set in the paper tray was over
10 mm shorter than paper size
set in the machine during faxing
or printing a list or report.
8E02 2-45
Toner Ended Open the Front
Cover, replace
Toner Cartridge.
Toner cartridge has reached the
upper limit in the continuous
printing mode.
4E01 2-38
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
