5.System Maintenance
108
does not change.
[-40.0 to 40.0 / -7.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / -7.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / -7.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
DFU
Sets the destination and updates the engine setting.
[DOM/ NA/ EU/ ASIA/ CHN/ TAIWAN]
Sets the machine operation at "waste toner full" of the refilled AIO.
[On or Off (Default)]
With the main motor rotation count feature, the machine can be set