5.System Maintenance
109
to stop printing after the print total exceeds a certain set value. If the
print count exceeds this value, then "Replace Print Cartridge"
remains in the display. Then a new AIO cartridge must be installed.
This feature is a safety measure to prevent the used toner tank from
becoming full (there is no toner overflow detection mechanism).
Adjusts print density (density levels by increasing the number)
[42 to 106 / 74 (Default) / 1 /step]
DFU
[Auto refill mode/ Pure refill mode]
Displays the number of pages printed with coverage 0 to 2%.
Displays the number of pages printed with coverage 3 to 4%.
Displays the number of pages printed with coverage 5 to 7%.
Displays the number of pages printed with coverage 8 to 9%.
Displays the number of pages printed with coverage 10 to 19%.
Displays the number of pages printed with coverage 20 to 29%.
Displays the number of pages printed with coverage above 30%.
Displays the power on counter.
Displays the sleep recover counter.
DFU
Displays the machine series number.
DFU
Displays the machine serial No.
Sets the Inrush Control mode. When using with an external power
supply instead of a commercial power supply, set to "On".
[Off (Default)/ On]
Sets the Flicker Control mode.
[Off (Default)/ On]
Scan Maintenance (Only for MF Models)
Sets the monochrome compression type for scanning.
MH (Default)/ MR/ MMR
Adjusts the ADF Scan main-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1 mm/step]
Adjusts the ADF Scan sub-scan registration.
[-2.0 to 2.0 / 0 (Default)/ 0.1mm/step]
Adjusts the Flatbed Scan main-scan registration.