5.System Maintenance
111
[Inactive (Default)/ Active]
System Maintenance
Sets whether the Air Print function is enabled or disabled
[Disable/ Enable (Default)]
[Off (Default)/ NIC/ USB]
@Remote
Sets the toner supply alarm.
[Disable (Default)/ Enable]
[At rplcment / At NearEnd]
Sets the SC call.
[Disable/ Enable (Default)]
Sets the user call.
[Disable/ Enable (Default)]
Sets the communication test call.
[Disable/ Enable (Default)]
Sets the machine information notice.
[Disable/ Enable (Default)]
Supply Auto
Ordering Call
Sets the supply auto ordering call.
[Disable/ Enable (Default)]
Displays the ID2 code (ASCII 17digits).
Performs the CE Call at the start or end of the service.
Enables or disables the remote service function.
[Disable (Default)/ Enable]
Executes the communication test.
Executes the device information notification.
Displays the RCG registration status.
[0 to 2]
Displays the URL for RCG center.
Sets the polling interval.
[0 to 4294967295 / 60 / 1 sec/step]
Specifies the connect timeout interval when calling the RCG.