5.System Maintenance
122
Pressing the Stop/Clear key can stop the current receiving
operation. Received data is lost.
[No Functional (Default)/ Functional]
Sets the Off-Hook detection period.
[200 msec (Default)/ 800 msec]
[0~9 / 2 (Default/ 1digit/step]
[1~3 / 2 (Default/ 1time/step]
[Limitless / 10 sec (Default/ 20 sec / 30 sec / 40 sec]
Sets the redial interval when Tx fails.
[5 Min (Default)/ 6 Min]
Sets the number of redials when Tx fails.
[2 times (Default)/ 3 Times/ 4 Times/ 5 Times]
Overseas
Comm Mode
Settings
This sets the machine to ignore a DIS signal sent from the called
station once in a sending operation.
[Off (Default)/ Ignore DIS Once]
If this setting is set to "On", the machine detects the CNG signal
after the line is connected. If it is set to "Off", the machine
detects the CNG signal as long as the line is connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
This sets the number of pulses that are generated during dialing.
N: Dialing '0' generates 10 pulses --- Dialing '9' generates 9
pulses. (Default)
N+1: Dialing '0' generates 1 pulses --- Dialing '9' generates
10 pulses.
10-N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 1 pulse.
Tone Signal
Transmission T
Sets the tone signal transmission time length
[100 ms (Default)]
Minimum Pause
In Tone Dial
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Attenuator of
Pseudo Ring
Sets the attenuator for pseudo ringback tone to the line
[0 to 15 / 10 (Default)/ 1 dB/step]
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu (Default)/ -8 dBu/ -6 dBu]