Ricoh SP 3510SF - Page 10

10
Using the Copier Function
Press the [Start] key.
If you are using the SP 3510SF model,
depending on the machine's settings, "Set
Back Side" appears on the screen when
using the exposure glass.
•Ifyouwanttocopythebacksideofthe
original, proceed to the next step.
•Ifyouwanttoendthejob,press[
]. A
copy will be output.
CMF141
Turn over the original on the exposure glass, and then press
the [Start] key.
A 2-sided copy will be output, and "Set Front Side" appears on the
screen.
•If youwant tocopy the frontsideoftheoriginalagain,turnoverthe
original on the exposure glass, and then return to step 4.
•Ifyouwanttoendthejob,press[
]. If a certain period of time passes
before you press [
], the copying may finish automatically.
To cancel photocopying, press the [Copy] key, press the [Clear/Stop] key, and then press •
[Yes] for confirmation.
You can change the paper tray for the current job by pressing the [ • ][ ] keys. You can also
select to change the paper tray automatically according to the paper size (A4 or Letter).
You can enable the machine to copy both sides of original with the exposure glass by •
changing the machine's default setting. For details, see "Configuring the Machine Using
the Control Panel", User Guide.
If a paper jam occurs, printing stops after the current page has been printed out. After the •
jammed paper is removed, printing restarts from the jammed page automatically.
If a scanning jam occurs in the ARDF or ADF, copying is canceled immediately. In this case, •
copy the originals again starting from the jammed page.
For information about originals, see “Getting Started”, • User Guide.
For information about removing jammed paper, see “Removing Paper Jams” on page 32. •
Initial Screen and Basic Operation