Ricoh SP 3510SF - Cover Open; Error and Status Messages on the Screen

26
Troubleshooting
Error and Status Messages on the Screen
“X” indicates the parts of the messages that appear differently depending on a spe-
cific situation, such as paper sizes, paper types, or tray names.
Message
(alphabetical order)
Causes Solutions
ADF Orig. Misfeed
Open ADF Cover
and remove paper.
An original has been
jammed inside the
ARDF or ADF.
•Removejammedoriginals,
and then place them again.
See "Removing from the
ARDF or ADF" on page 40.
•Checktheoriginalsaresuit-
able for scanning. See "Plac-
ing Originals", User Guide.
Check Paper Size
The paper size set for
the document differs
from the size of the
paper in the tray.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Check Paper Type
The paper type set for
the document differs
from the type of the
paper in the tray.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Cover open
A cover is open. Close the cover completely.
Dest. is not
Programmed
No Quick Dial entry
is associated with the
One Touch button you
pressed.
•PressadifferentOneTouch
button.
•Assignaregistereddestination
to the One Touch button. See
"Registering Scan Destina-
tions", User Guide.
Failed to Access
File Press Clear key
The Scan to USB
function failed
because the machine
could not access
the USB flash disk
properly.
Use a USB flash disk that is not
password- or write-protected.
Failed to Create File
Press Clear key
The Scan to USB
function failed
because there was
not enough memory
on the USB flash disk.
Use a USB flash disk with
enough memory.