Ricoh SP 3510SF - Removing Internal;Tray 1;Tray 2 Jam

32
Removing Paper Jams
Removing Internal/Tray 1/Tray 2 Jam
CAUTION
The inside of this machine becomes very hot. Do not touch the parts labelled “ • “
(indicating a hot surface).
Some of this machine’s internal components get very hot. For this reason, take care •
when removing misfed paper. Not doing so could result in burns.
Whenremovingjammedpaper,makesurenottotraporinjureyourngers. •
Jammed paper may be covered in toner. Be careful not to get toner on your hands or •
clothes.
Toner on prints made immediately after clearing a paper jam may be insufficiently fused and •
can smudge. Make test prints until smudges no longer appear.
Do not forcefully remove jammed paper, as it may tear. Torn pieces remaining inside the •
machine will cause further jams and possibly damage the machine.
Paper jams can cause pages to be lost. Check your print job for missing pages and reprint •
any pages that did not print out.
Pull tray 1 halfway out, and check
for jammed paper. If there is
jammed paper, remove it carefully.
CMF067
Carefully slide tray 1 back in until it stops.
If paper is loaded in the bypass tray, remove the paper.
Close the bypass tray.
Push the side button to open the front cover, and then care-
fully lower it.