Ricoh SP 3510SF - Removing Bypass Tray Jam

34
Removing Paper Jams
CAUTION
The inside of this machine becomes very hot. Do not touch the parts labelled “ • “
(indicating a hot surface).
Some of this machine’s internal components get very hot. For this reason, take care •
when removing misfed paper. Not doing so could result in burns.
Whenremovingjammedpaper,makesurenottotraporinjureyourngers. •
Jammed paper may be covered in toner. Be careful not to get toner on your hands or •
clothes.
Toner on prints made immediately after clearing a paper jam may be insufficiently fused and •
can smudge. Make test prints until smudges no longer appear.
Do not forcefully remove jammed paper, as it may tear. Torn pieces remaining inside the •
machine will cause further jams and possibly damage the machine.
Paper jams can cause pages to be lost. Check your print job for missing pages and reprint •
any pages that did not print out.
If paper is jammed in the bypass
tray input area, remove the jammed
paper carefully.
CMF073
Close the bypass tray.
Push the side button to open the front cover, and then care-
fully lower it.
Carefully pull out the print cartridge
horizontally, holding its center.
•Donotshaketheremovedprintcartridge.
Doing so can cause remaining toner to
leak.
•Place the print cartridge on paper or
similar material to avoid dirtying your
workspace.
CMF069
Removing Bypass Tray Jam