Ricoh SP 3510SF - Where to Inquire; Saving Energy

Where to Inquire
Contact your sales or service representative for further information about topics
covered in this manual or to inquire about topics not covered in this manual.
Saving Energy
This machine is equipped with the following Energy Saver modes: Energy Saver
mode 1 and Energy Saver mode 2. In Energy Saver mode, the machine’s power
consumption is reduced from its normal state.
If Energy Saver modes 1 and 2 are enabled, the machine will enter Energy Saver
mode 1 if it has been idle for 30 seconds. If the machine continues to be unattend-
ed, it will then enter Energy Saver mode 2 after specified period of time (1 minute
by default). The machine takes about 10 seconds to recover from Energy Saver
mode 1, and about 20 seconds to recover from Energy Saver mode 2.
According to your convenience, you can enable or disbale Energy Saver modes,
as well as configure the timer for entering Energy Saver mode 2, in [Energy Saver
Mode] under [Admin. Tools].
Even if Energy Saver mode 2 is enabled, the machine will not enter Energy Saver mode 2 for •
two hours if [Low Humidity Mode] under [System Settings] is enabled. However, the machine
will enter Energy Saver mode 1 as normal (even when Energy Saver mode 1 is not en-
abled).
For details about Energy Saver modes, see “Administrator Settings”, • User Guide.
For details about [Low Humidity Mode], see “System Settings”, • User Guide.
Print Cartridges
49
Appendix