Problem Solution
Prints do not stack properly. • The paper being used may be damp. Use paper that has
been stored properly. See page 41 "Supported Paper".
• Select [Level 2] or [Level 3] in [Anti-Humid Lvl] under
[Maintenance]. Note that if you select [Level 2] or [Level
3], the first print takes longer than subsequent prints.
• Pull up the appropriate stop fence (forward fence for
A4/Letter, rear fence for Legal size prints). See page 13
"Guide to Components".
The printed paper is curled. • Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly.
• Select [Level 1], [Level 2] or [Level 3] in [Anti-Humid Lvl]
under [Maintenance]. Note that if you select [Level 2] or
[Level 3], the first print takes longer than subsequent
prints.
Printed envelopes come out creased. Check if the fusing unit levers are properly set. Lower the fusing
unit levers.
Other Printing Problems
Problem Solution
The toner has run out and printing
has stopped.
When the toner runs out, pressing the [Stop/Start] key allows
you to print a few more pages, but the print quality of those
pages may be lower.
Printer Problems
179
To Next Page
Loading...
Need help?
General
Weight and Dimensions
