8
Safety Instructions for Laser
This saw has a built-in laser light. The laser is class IIIa and
emits output power of a maximum 2.5mW and 630~670nm
wavelengths. The laser doesn’t normally present an optical
hazard.
CAUTION
The following label is on your saw. It indicates where the
laser light is emitted by the saw.
CAUTION:
Avoid exposure. Laser radiation is emitted through this
aperture.
CAUTION:
The use of controls or adjustments or the performance
of procedures other than those directed in this manual
may result in hazardous radiation exposure.
WARNING:
Laser radiation. Avoid direct eye exposure. Do not stare
into the beam. Turn the laser on only when the tool is
operated.
Be sure to read and understand all instructions. Always
follow the following safety rules when using this saw:
NEVER aim the beam at any person or at any object
other than the work piece.
DO NOT look directly into the laser-beam output aper-
ture during operation. The laser beam can be harmful to
the eyes.
ALWAYS keep the laser out of the reach of children. The
laser on the saw is not a toy.
Using optical instruments with this product will increase
eye hazard.
DON’T ATTEMPT TO REPAIR OR DISASSEMBLE the
laser. If unqualified persons attempt to repair this prod-
uct, serious injury may result. Any repair required on this
laser product should be performed by authorized ser-
vice-center personnel.
SPECIFIC SAFETY INSTRUCTIONS
FOR RIDGID WET TILE/STONE SAW
To Next Page
Loading...
