• Configure
AA-xxx Analyzer – select the corresponding analyzer
Imported data – this menu is automatically selected if
the data was imported from a CSV or an S1P file
COM port… – select virtual COM port number or serial
device name, if needed (only for AA-230 ZOOM)
Units – set metric or US units
System impedance – set reference impedance for the system
(usually 50 or 75 Ohm)
Apply OSL calibration – apply calibration data to
the current display (see below)
Save last measured data – save calibration data (see below)
Parameters of calibration standards – select a model or load
the parameters (see below)
Cable parameters – enter cable impedance, velocity factor,
cable loss, etc.
Transmission line options – add or subtract cable from
12
To Next Page
Loading...
