Need help?Do you have a question about the Rigol DHO802 and is the answer not in the manual?
General| Bandwidth | 70 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GSa/s |
| Vertical Resolution | 12-bit |
| Interfaces | USB Host, USB Device, LAN |
| Input Coupling | DC, AC, GND |
| LAN Port | 1 |
| Waveform Capture Rate | 500, 000 wfms/s |
| Display | 7-inch LCD (1024 x 600) |
| Input Impedance | 1 MΩ || 16 pF |
| Max Input Voltage | 300 Vrms |
| Trigger Types | Edge, Pulse, Video, Slope, Pattern |
| USB Ports | 2 (1 USB Host, 1 USB Device) |
Precautions to avoid injury or instrument damage during operation.
Explains warnings, cautions, and safety symbols used in the manual.
Details the instrument's measurement category and definitions.
Steps to inspect packaging, instrument, and accessories upon receipt.
Steps to get the instrument ready for operation, including supporting legs.
Procedure to compensate probes for accurate measurements.
Explains the main display elements, labels, and toolbars.
Explains setting parameters using knobs and the virtual keypad.
How to change the V/div setting for waveform amplitude.
How to change the vertical position of the waveform relative to ground.
How to set the time/div scale for horizontal waveform display.
Explains Normal, Average, Peak, and UltraAcquire acquisition modes.
How to select analog channels or external trigger as the signal source.
How to set the voltage level that initiates a trigger event.
Explains Auto, Normal, and Single trigger modes for acquisition control.
How to trigger based on the rising or falling edge of a signal.
How to trigger based on the width of a pulse.
How to trigger based on the slope of a signal's edge.
How to trigger on standard video signals like NTSC and PAL.
How to trigger based on a specific logic pattern across channels.
How to trigger based on the duration of a specified pattern.
How to trigger on RS232 serial data based on frame conditions.
How to trigger on I2C serial data based on address and data conditions.
How to trigger on SPI serial data based on clock and chip select signals.
Automatic waveform scaling and measurement of signal parameters.
How to access and configure automatic measurements.
How to use cursors to measure X and Y values on waveforms.
Activating or deactivating the pass/fail test for signal quality check.
Configuring decoding parameters for RS232 serial communication.
Configuring decoding parameters for I2C serial communication.
Configuring decoding parameters for SPI serial communication.
Connecting and controlling the instrument via USB using SCPI commands.
Connecting and controlling the instrument via LAN using network interface.
Steps to diagnose and resolve issues with no signal display.
Troubleshooting steps for USB device recognition problems.
Steps to resolve issues with the touch screen interface.
To Next Page
