Need help?Do you have a question about the Rigol DHO804 and is the answer not in the manual?
General| Bandwidth | 70 MHz |
|---|---|
| Channels | 4 |
| Waveform Capture Rate | 1, 000, 000 wfms/s |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Vertical Resolution | 12 bits |
| Interfaces | USB, LAN, HDMI |
| Input Impedance | 1 MΩ ± 1% |
| Max Input Voltage | 300 Vrms CAT I |
| Trigger Types | Edge, Pulse, Slope, Video, Pattern, Duration, Timeout, Runt, Window, Delay, Setup/Hold, Nth Edge, Logic |
| Protocol Decoding | I2C, SPI, UART, CAN, LIN, FlexRay, I2S |
| USB Ports | USB Host, USB Device |
| LAN Port | 1 |
Key safety precautions for operating the instrument to avoid injury or damage.
Explains warning, danger, and caution symbols used in the manual.
Lists the main technical specifications and capabilities of the DHO800 series.
Inspect packaging, instrument, accessories, and perform initial checks.
Guide on connecting power, probes, and performing the turn-on checkout.
Guide on adjusting the vertical position (offset) of the waveform display.
Setting trigger source, level, mode, coupling, holdoff, and noise rejection.
Configuring Edge, Pulse Width, Runt, Slope, and Window triggers.
Setting up Video, Pattern, Duration, Timeout, Delay, Setup/Hold, Nth Edge, RS232, I2C, SPI triggers.
Details arithmetic operations and how to view their results.
Details Peak Search functionality, including settings for number, threshold, and excursion.
Covers filter types (LowPass, HighPass, BandPass, BandStop) and frequency limit settings.
Using Auto Scale and configuring auto measurements for various parameters.
Details measurement items (Time, Count, Voltage etc.) and their settings.
Using Manual, Track, and XY modes for cursor measurements on waveforms.
How to enable the test, select source, create and manage masks.
How to start/stop the test, view statistics, and manage results.
Configuration and parameters for decoding parallel bus signals.
Setup and parameters for RS232 and I2C serial protocol decoding.
Configuration, data settings, and event table for SPI serial protocol decoding.
How to search for events like edges and pulses and manage search setups.
To Next Page
