Rigol DHO804 User Manual

TIP
When the voltage of signal source B is 0 V, the division result is treated as 0.
Figure 9.3 Arithmetic Operation Menu
Operation Result Display Window
Click or tap the
Operation on/off switch to enable the display of the arithmetic
operation result window. The source and the vertical scale parameters are displayed
at the top of the window, as shown in the figure below.
Source Vertical Scale
Label
Sample Rate
Figure 9.4 Operation Result Display Window
Math Operation
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved. DHO800 User Guide
107

Rigol DHO804 Specifications

General

Bandwidth	70 MHz
Channels	4
Waveform Capture Rate	1, 000, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	12 bits
Interfaces	USB, LAN, HDMI
Input Impedance	1 MΩ ± 1%
Max Input Voltage	300 Vrms CAT I
Trigger Types	Edge, Pulse, Slope, Video, Pattern, Duration, Timeout, Runt, Window, Delay, Setup/Hold, Nth Edge, Logic
Protocol Decoding	I2C, SPI, UART, CAN, LIN, FlexRay, I2S
USB Ports	USB Host, USB Device
LAN Port	1